Oz Tuning - Welcome to Oz
  • UNDERTAKER KIT 2 - Whipple 2.9L Supercharger Stage 2 - 2018+ F150 5.0L

    $14,495.00 $12,995.00
    Please read and type YES

    This is the kit that got into the low 10's!!!

    2018+ F150 5.0L WHIPPLE STAGE 2 Supercharger System.   

    • Includes our proven Oz Tuning Forced Induction Tune for FREE ($750 value)
    • Stage 2 Whipple SC w/132mm Throttle Body
    • 1-7/8" Kooks Headers w/catted Green y-pipe (Boost approved)
    • JD Performance Solutions Dual-pump, Drop-in Returnless Fuel Module
    • NGK IRIDIUM IX (LTR7IX-11) 6510 One Step Colder Plugs

       If you want the most advanced, most powerful, most upgradeable and highest quality system available, then here it is! Whipple Superchargers has yet again set a new precedence for bolt-on power with the all new DI/PI Stage 1 and Stage 2 Supercharger systems featuring the new Gen 4 2.9L Whipple twin-screw supercharger. The Stage 2 system bolts to the factory engine with no cutting or grinding and differs than the Stage 1 with its unique Roval 132mm billet throttle body vs the stock 80mm throttle body. 

    Whether you’re looking for a daily driver that needs a little more punch or you’re craving a tire-frying, rubber shredding street machine, the Whipple Supercharger systems delivers like no other SC system today. 

    • More power per lb of boost than any other system.
    • Massive air-to-water intercooler, oversized Crusher air system and innovative PCM programming that keeps the power-train safe and secure.
    • Power from tip in to redline.
    • Incredible power across the entire rpm range while maintaining industry leading drive-ability.
    • Comes with the new Whipple flash tool which allows each customer to load the calibration into the PCM, read and erase codes, octane adjust capacity and the ability to customize wheel/axle sizes.


    • 4th Generation Whipple twin-screw, the most powerful supercharger available
    • No other upgrades required, just massive power right out of the box
    • Front entry W175ax (2.9 liters) Whipple twin-screw supercharger that significantly outperforms competitions 2.3L and 2.65L roots-type systems
    • Front feed supercharger utilizes precision ground helical cut gears vs a problematic belt
    • Oversized Crusher™ inlet for maximum airflow capacity and minimal rotor cavitation
    • Front feed allows for oversized intercooler core compared to other smaller intercooler cores giving Whipple lower air charge temps which allows more boost and timing to be run on pump gas
    • Massive air-to-water aluminum bar-plate intercooler offers more cooling than any other positive displacement system available, nothing comes close
    • Massive oversized aluminum intercooler reservoir (over 2 gallons) holds more than double any competitors IC water system allowing longer more consistent power
    • Whipple Superchargers massive oversized intercooled air-bypass system for industry leading reduction of burst knock and incredible fuel economy
    • Self-contained oversized oil system for dramatically reduced oil temps in even the most demanding conditions
    • Exclusive 3x5 rotor combo for significant increase in airflow under the curve than less efficient 4x6 rotor combo or 4x4 roots
    • Center discharge port for better cylinder to cylinder distribution then other twin-screws with cobbled together billet adapters and forward facing discharge
    • W175ax SC bottom is open for increased plenum volume and better over-intercooler air distribution giving more intercooler effectiveness
    • Extra plenum volume below intercooler core for far less pressure drop
    • Discharge down design allows for less pressure loss which gives more power at lower boost levels
    • Top mount design allows for cooler operation then upside down SC's that conduct heat from engine and are trapped by runners and covers, causing hotter manifold temps and less power per pound of boost
    • More boost at the "hit" than any other twin-screw
    • Flat torque curve for incredible acceleration
    • Oversized heat exchanger for incredible intercooler water temps
    • Fits under factory hood with no modifications
    • No internal modifications required
    • Completed installation looks factory installed, not some cobbled together kit with multiple billet adapters
    • Kits come complete with all necessary parts and hardware for installation
    • Unique oil level sight glass for easy oil level and quality check, no dipstick to bind or misread
    • Plug and play wiring with male and female connections
    • Proven 6-rib belt system with heavy duty spring loaded tensioner and adjustable idler system
    • Stainless steel tapered jack-shaft with unique plastic cover (or optional carbon fiber) for increased safety
    • OEM quick connect fittings for easy installation, no ugly brass or steel fittings on the SC
    • Complete kits and Competition kits are available
    • Available in wrinkle black, polish, Ford textured blue or any custom color
    • Instant boost at the touch of the throttle
    • 3 minute pulley changes
    • Lightweight pocketed SC pulley
    • NGK IRIDIUM IX (LTR7IX-11) 6510 One Step Colder Plugs

    NOTE: If you are already tuned by us with a nGauge device, you will need to rent a MPVI2 tuner for datalogging.

    Click here.